Need help?Do you have a question about the Topcnc TC55H and is the answer not in the manual?
General| Number of Control Axes | 5 |
|---|---|
| Minimum Data Unit | 0.001mm |
| Number of Stepping Motor Control Axes | 5 |
| Handwheel Interface | Yes |
| Input Points | 24 |
| Output Points | 16 |
| Pulse Output Frequency | 500KHz |
| Interface | USB |
| Maximum Data Size | 999999.999mm |
Configures the relationship between pulses and movement distance.
Detailed list and explanation of G codes for motion control.
Command for rapid linear movement between points.
Command for linear movement at a specified feed rate.
Illustrates linear interpolation with absolute and incremental programming.
Command for clockwise circular interpolation.
Examples of clockwise circular movements using G02.
Command for counter-clockwise circular interpolation.
Examples of counter-clockwise circular movements using G03.
Sets the current position as new coordinate system origin.
Controls spindle, output ports, and program termination.
To Next Page
