In Auto Interface, Press start to run the last read program, Press Pause to Stop.
2.1 Step
Positive display means consecutive operation. Negative display means operate command by command.
When it is negative display, press Start once, one program line will be executed.
3.4.2 Edit
● Press Enter to insert new line.
● Long press DEL to delete a line.
● Press←→↑↓to move the cursor
● Top: To the fist line
● BTM: to the last line
● Test: See if there are any mistake
● Save: Save program
● Auto: Into Auto Interface.
To Next Page
Loading...
