Topcnc TC55H - Output Signal Configuration; Output Port Control

jiafengqi.xtf@hotmail.com
9
Z Lim-
Z axis Negative limit setting
Z 0
Z axis zero switch setting
Man Z+
Z axis clockwise spinning outside manual switch
Man Z-
Z axis counter clockwise spinning outside manual switch
Z Boot Zero
Z axis go back to Machine zero after booting external manual switch
C Lim+
C axis Positive limit setting
C Lim-
C axis Negative limit setting
C 0
C axis zero switch setting
Man C+
C axis clockwise spinning outside manual switch
Man C-
C axis counter clockwise spinning outside manual switch
C Boot Zero
C axis go back to Machine zero after booting external manual switch
4.4 Output
In this interface to define the open and close of 1-8 output port, then you can directly use in programming.
M03-M04 is spindle interlock.
4.5 FTY
Go back to factory value.