Topcom T41 - Additional Settings Configuration

Topcom T41 7
ENGLISH
Topcom T41
• Press the - button. ‘SET 1 DATE’ is displayed.
• Press repeatedly the - button or the - button until ‘SET 2 ACODE’ is
displayed
• Press the - button to confirm.
• Use the - button or the - button to select the first digit of the local code (0~9
or "_" to unselect)
• Press the - button to confirm the first digit and change to the next digit
• Repeat the previous steps for the digits (max. 5 digits). When no local prefix is
used set, LCD displays: ‘ACODE _ _ _ _ _’
• After confirming the last digit, you will go to the next setting.
9.4 Set flash time
You can set the flash time of T41 as different time: 110ms, 300ms, 600ms and 1000ms.
• Press the - button, “SET 1 DATE” is displayed.
• Press repeatedly the - button or the - button until “SET 3 FLASH“ is
displayed
• Press the - button, the LCD shows: “FLASH 3 110” (110 is the flashtime).
• Press the - button or the - button to select your desired flash time
• Press the - button to confirm your selection and to go to next item setting
9.5 Setting the display contrast
You can select the desired contrast as follows:
• Press the - button, “SET 1 DATE” is displayed.
• Press repeatedly the - button or the - button
until “SET 4 LCD” is
displayed.
• Press the - button again to enter LCD contrast setting mode
• Use the - button or the - button to select the desired display contrast
• Press the - button to confirm your selection and go to next setting item
The display contrast can also be changed by pressing the ‘ ’ repeathely in
standby.