Topcom T41 - Call List and Memory Functions; Call List Operations; Adding to Direct Memory

Topcom T41 9
ENGLISH
Topcom T41
10.2 Call list
Max. 63 incomming phone numbers will stored in the call list.
When a phone number received more than once, the repeat indicator REP is displayed.
Every incoming number is saved in the Call List with indication of date and time. In
standby mode the number of received calls is shown on the display with indication of
date and time. The new message indicator NEW will blink until you have checked all
new messages.
10.2.1 Scrolling through the Call List
10.2.1.1 Check incoming call list
• Press the - button or the - button to enter incoming call list.
• Press button or to scroll through the list.
• If no button is pressed within 5 seconds, you will return to stand-by mode.
10.2.2 Calling a number from the Call List
• Select the desired telephone number.
• Press the ‘ ’ - button. The number will be dialled automatically in hands free
mode.
• Pick up the handset if you want to communicate over the handset.
10.2.3 Erasing numbers from the Call List
10.2.3.1 Erasing one number
• Select the number you wish to erase.
• Press the ‘ ’ - button to delete the number from list. The next number in the call
list is displayed.
10.2.3.2 Erasing the entire Call List
• Enter the Call List and select a number
• Press and hold button the ‘ ’ - button for 4 seconds. All number in the list will be
deleted
11 Memory number
You can program 12 phonenumbers in the indirect memory (max 16 digits).
11.1 Adding a number to a Direct Memory
• Enter the telephone number.
• Press the ‘ ’ button
• Press the desired Memory location (0 ~ 9, *, #)
Note: Direct memories can only be overwritten but not be erased.