Need help?Do you have a question about the Topcon GREEN LABEL GTS-255 and is the answer not in the manual?
General| Brand | Topcon |
|---|---|
| Model | GREEN LABEL GTS-255 |
| Category | Measuring Instruments |
| Language | English |
Detailed safety instructions and definitions of warnings and cautions for product use.
Step-by-step guide on mounting, leveling, and centering the instrument on a tripod.
Explanation and setup of automatic tilt correction for angles.
Procedure for measuring horizontal and vertical angles to targets.
Performing continuous, multi-time, fine, coarse, and tracking distance measurements.
Performing stake out operations and various offset measurements (angle, distance, plane, column).
Setting occupied point coordinates, instrument height, and prism height for measurements.
Steps for measuring unknown point coordinates after setting up necessary parameters.
Measuring distances and angles between target prisms for missing line calculations.
Calculating areas, measuring offset points to lines, and road measurement functions.
Step-by-step procedures for collecting data, including offset measurements.
Preparing for layout, setting grid factor, selecting files, and defining occupied/backsight points.
Executing layouts and setting new points using side shot or resection methods.
Guidelines for removing, charging, and storing the battery to maintain performance.
Procedures for checking and adjusting the instrument's constant for accuracy.
Adjusting vertical angle zero datum and systematic errors for instrument accuracy.
List of error codes, their descriptions, and recommended countermeasures for troubleshooting.
To Next Page
