Safety instructions, guarantee and liability
Page 6
2 Safety instructions, guarantee and liability
2.1 Common
Read this operating manual before commissioning the OPUS B2/B2 Plus. Keep this
operating manual where it is accessible to all users at any time. Every person who is
assigned to commission or operate the OPUS B2/B2 Plus must have read and
understood the operating manual and the safety instructions in particular!
This operating manual contains instructions that must be complied with for your
personal safety and to avoid damage to property. Failure to follow these safety
instructions could result in fire, electric shock, or other injury or damage to OPUS B2/B2
Plus or other property.
2.2 Qualified Personnel
This operating manual is intended for technically qualified personnel, who have the
appropriate skills in measurement, control, and regulating technology.
Precise knowledge of all safety instructions and warnings contained in this operating
manual, as well as problem-free technical implementation of these instructions and
warnings are the prerequisites for hazard-free installation, commissioning, safe
operation, and maintenance, of the operator panel. Consequently, it is strictly required
that all measures be performed by qualified personnel.
Qualified personnel, in accordance with the safety and warning instructions contained
in this operating manual are personnel, who
are familiar with CAN bus systems, related protocols and network designs that
fulfill all legal requirements of the intended application, so that they are able to
program the OPUS operator panel accordingly
have gained knowledge of the programming related concepts by education or
trainings. Using the Projektor Tool a Projektor Tool training by Topcon needs to
be attended. Using CODESYS a CODESYS training needs to be attended,
either held by Topcon or 3S.
are familiar with the safety concepts of automation technology, either as project
design personnel
or operating personnel who have been instructed in how to handle the
automation technology, and who are familiar with the section of this manual
which deals with operation.
or who, as commissioning, and service personnel have been trained to repair
this type of automation technology, or who are authorized to commission,
ground, and label electrical circuits and devices, or systems, in accordance with
technical safety standards.
All persons who are involved in project planning, installation and operating the OPUS
B2/B2 Plus must be familiar with automation technology safety concepts, and they
must be qualified in accordance with the guidelines listed above.
To Next Page
Loading...