Safety instructions, guarantee and liability
Page 8
Moreover, we expressly declare that all obligations on the part of Topcon are
exclusively derived from the respective purchase contract, in which the guarantee is
conclusively stipulated.
2.5 Safety Instructions for the OPUS B2/B2 Plus
Dangerous high voltage
Never attempt to repair or modify OPUS B2/B2 Plus yourself.
Disassembling OPUS B2/B2 Plus may cause damage that is not
covered under the warranty and cause hazardous conditions by
the high-voltage components inside of the unit.
OPUS B2/B2 Plus does not contain any user-serviceable parts.
Service should only be provided by Topcon Electronics GmbH.
Hazardous situations due to device failure
Do not use the OPUS B2/B2 Plus as the sole means of preventing
hazardous conditions on vehicles, machines and equipment.
Vehicles, machines and equipment must be constructed in such
a manner that defective conditions associated with the OPUS
B2/B2 Plus cannot cause a hazardous situation for operating
personnel.
Ensure that incorrect inputs via the OPUS B2/B2 Plus, its
malfunction, or its failure cannot lead to major property damage,
or to a hazard for operating personnel.
Missing safety devices if used improperly
Precautions for the safety of a system should not be rendered
inoperable through the use of the OPUS B2/B2 Plus.
Emergency-Stop devices must remain effective in all operating
modes.
Unintentional operation
Operating states can be called due to unintentional operation of
the OPUS B2/B2 Plus that are not appropriate for the situation.
OPUS B2/B2 Plus devices should be installed in such a manner
that the possibility of unintentional operation is adequately
excluded.
TOPCON is not liable for injuries to third party licenses for the
contents used on OPUS panel by the end customer.
To Next Page
Loading...
