10
Control Panel
Auto/manual leveling control
Leveling lamp
Power switch
Manual mode lamp
Mode switch control
Scan mode
Laser sensor mode
Laser pointing mode
X/Y axis selection key
X/Y axis lamp
Head rotates slowly,
searching for Magnetic
Scanning Target. When
target is placed in beam
path, laser rapidly scans
back and forth on target.
Laser sensor mode
Head rotates at 300 rpm.
Use this setting when using
an optional electronic laser
sensor such as the Topcon
LS-70.
Head stops rotating and the
beam can be positioned by
manually turning the head.
Select X or Y axis for
manual beam sloping.
ON: Manual leveling mode
OFF: Auto-leveling mode
ON/OFF of Auto-leveling. To turn
off the auto-leveling, press this
key twice. To turn on the auto-lev-
eling again, press this key once.
Circular level for
vertical operation
Flashing: Laser is leveling
On: Auto-leveling is completed
(RL-VH3C remote control model has
standby mode)
Laser mode is switched
alternately as follows.
Speed control
With 'Laser Point-
ing Mode'
selected, the rota-
tion speed of the
head can be
changed.
Alignment
control
Low battery alert
To Next Page
Loading...
