Topcon RL-VH3C - RC-30 Remote Control Function Details

35
Description of RC-30 functions
Laser power
switch
(Standby mode)
Pressing for more than three seconds turns
laser standby mode on or off. Laser turns off
if standby mode continues for two hours.
Transmission
lamp
This lamp will indicates a signal is being transmitted by the RC-30.
It should illuminate any time a control pad is pressed.
Battery warning
lamp for RC-30
Battery warning for RC-30.
Replace the batteries with new ones.
Stop beam control
Sets Stop Beam mode and moves laser. (RL-VH3G/A/B models only)
Speed control
The rotation speed of the rotary head can be changed.
Alignment control
Moves beam up or down (horizontal rotation).
Moves beam right or left (vertical rotation).
X/Y axis lamp
Indicates axis selected during beam sloping operation.
Laser Power
switch
(Standby mode)
Tur ns laser standby mode on or off by pressing this key for more than
three seconds.
(The RL-VH3C will be turned off automatically if the standby mode is
continued for 2 hours)
Mode switch
control
Laser mode is switched alternately as follows.
Scan mode / Laser sensor mode / Laser pointing mode.
Manual focus
control
Laser beam can be focused manually.
(RL-VH3G/A models only)
X/Y axis selection
Sets slope mode by pressing for more than three seconds.
Select X or Y axis for manual grading.
To cancel the slope mode press this key for more than three seconds.