3.6 Menu Transparency 19
Display Format
If you have a TV set with the 4:3 picture format and transmis-
sion is in 16:9, you can select the display format. Select the
Letter Box or Center extract by using
b
,
d
buttons.
Sound Mode
It allows you to configure the sound mode. Select the Stereo,
Mono, Left and Right mode by using
b
,
d
buttons. The Sound
mode is configurable later on by using the sound button
on your remote control.
RF Output
When the digital receiver is connected to the TV by an RF ca-
ble, you may need to select the correct TV standard system.
Select the PAL G, PAL I, PAL K, NTSC M mode by using
b
,
d
buttons.
RF Channel
Select a RF channel by using
b
,
d
buttons. The default RF
channel is CH36. When you change the RF channel number,
you must also change to the same value on the TV. If you do
not, there will be no picture and sound.
3.6 Menu Transparency
To adjust the transparency level of the menus and the other
on-screen display , select the System Setting > OSD Trans-
parency menu. The available levels are ranging from 0% to
50%.
3.7 Display Time of The Information Box
Refer the information box to Section 5.2 on page 24.
To Next Page
Loading...
Need help?
General