TorcUP VOLTA VT Series - Battery Specifications; Charger Specifications; Vibration Information; Noise Information

25
23
BATTERY SPECIFICATIONS
Nominal Voltage
Typical Capacity 4 Ah 5.5 Ah 8 Ah
Energy 72Wh 99Wh 144Wh
Chemical system
Designed for Recharge
WARNING:
Only use TorcUP approved batteries.
Do not allow battery packs to come in contact with water.
Do Not expose battery packs to heat or fire.
Discharge battery pack before disposal. Prevent contacts from short-circuting.
Do not dispose of battery packs with household waste. Observe national regulations on proper
disposal.
CHARGER SPECIFICATIONS
Air cooled
Input
Mains frequency
Output
Charge time
VIBRATION INFORMATION (ALL TOOL SIZES)
Vibration < 2.5 M/s2
Uncertainty 1.5 M/s2
WARNING: The vibration emission value during actual use of the power tool
can differ from the declared value depending on ways in which the tool is used.
NOISE INFORMATION (ALL TOOL SIZES)
L
pA /
K
pA
dB(A) 76 / 3
LWA / KWA
dB(A) 87 / 3
WARNING: Wear ear protection when sound pressure is over: 80dB(A)
ENVIRONMENTAL SPECIFICATIONS
CAUTION!
TEMPERATURE RANGE FAHRENHEIT CELSIUS
Operating 5-122 -15 - 50
Charging 32-122 0 - 50
Storage 50 - 86 10 - 30
Humidity
Required Operating Conditions
Non Explosive Atmoshere.
Dry Location
18V
Lithium Transition Metal Oxcide (Li[M]m[O]n)
Yes
30 minutes at 1.5 Ah
18 VDC
50-60 Hz
110v or 220v
Only operate the Volta Series Battery wrenches if the following storage and
operations condidtions have been met.
10% - 90% non condensing
In accordance with EN 60745
In accordance with EN 60745