Tork EWZ201C User Manual

14
4. Upon powering up your EWZ201 the display will show
at what frequency the unit is operating, 50 will determine
50Hz or 60 for 60Hz.
5. While in the AUTO mode, if AC power is absent, the dis-
play will show a PF (power failure) instead of the seconds
scrolling up.
6. A “Lo” on the display indicates that the super cap has
run low and the unit needs to be powered with AC. A mini-
mum of 8 hours is required to fully charge the super cap.
7. A “PF” on the display indicates power failure. Timer will
not operate in this mode. If power has been restored t the
unit and “PF” still shows, try to reset the unit by inserting
a small pin or paper clip into the small hole next to the
EVENT key and re-setting the clock and date.

Tork EWZ201C Specifications

General

Type	Digital Timer
Voltage	120-277 VAC
Amperage	20A
Number of Channels	1
Backup	Battery backup
Contact Type	SPDT
Display	LCD
Programming	7-Day
Horsepower	1 HP
Mounting	Surface
Operating Modes	Automatic, Manual
Enclosure	NEMA 1