Assembly Instructions
for the PCNC 770 Stand
For a slideshow of the PCNC 770 Stand assembly, please visit: www.tormach.com
Contents
1. Getting Started ................................................................................................................................................. 3
2. Receiving the Stand .......................................................................................................................................... 4
3. Attach the feet to the stand ............................................................................................................................. 5
4. Lift the mill on to the stand .............................................................................................................................. 7
5. Bolt the PCNC on the stand .............................................................................................................................. 7
6. Installing oil pump ............................................................................................................................................ 7
7. Attach the Coolant Trays .................................................................................................................................. 8
8. Installing back splash ........................................................................................................................................ 9
9. Coolant System Installation .............................................................................................................................. 9
10. Table Mounted Splash Guard ........................................................................................................................ 11
11. Machine Arm .................................................................................................................................................. 12
To Next Page
Loading...
Need help?
General
