3. Attach the feet to the stand
Once the pallet is removed and while the base is still on its
side is a good time to attach the feet to the stand. First
grease the inner and outer threads on the feet Figure 4
Otherwise they will rust and future adjustment will be
impossible.
Next insert the bolt into the foot pad and place the
spacer on the bolt as shown in Figure 5. The spacer brings
the stand to the correct height and makes room to for a
pallet jack under the stand.
To review foot steps are:
1. Place the Spacer (3) onto the bolt of Iron Foot Pad
(4);
2. Insert the bolt of the Foot Pad (4) into the bottom
of the stand;
3. Add the Flat Washer (2) and Nut (1) and tighten.
Parts are shown in Figure 6
Figure 4. Greasing the stand feet.
Figure 5. Bolt and foot spacer installation.
Figure 6. Foot bolt parts
To Next Page
Loading...
Need help?
General
