Instructions for Use iMotion 1302.KI T-1737 e 5
2 Safety
2.1 Responsibilities
For instructing the operator: A skilled person from a TORMAX sales partner
For operating the system: The operator or a person instructed by the operator
For maintenance and function control: The operator or a person instructed by the operator
For annual testing and approval: A skilled person authorised by the manufacturer
Skilled persons are persons who have adequate knowledge in the field of power-operated doors as a
result of their specialist training and experience and who are so familiar with the relevant health and
safety regulations, guide-lines and generally recognised codes of practice that they are able to assess
the condition of power-operated doors with regard to the safety of their operation.
Maintenance of electrical parts must be carried out by a trained electrician.
2.2 Use for the Purpose Intended
The automatic swing door is intended exclusively for use in dry premises in areas used as a pedestrian
thoroughfare within the specified technical data. Special techniques can also be used to attach the
drive unit to the building envelope. The manufacturer will not accept any liability whatsoever for loss or
damage caused by improper use, failure to comply with the maintenance specification (see section 6)
or unauthorised modification of the system.
2.3 Pre-Conditions for the Operation of the System
The door system was designed, installed and checked for functionality and safety by skilled persons
prior to hand-over to the operator. The company responsible for the system’s installation instructed the
operator on the system’s use and maintenance as well dangers associated with the system operation.
The operator has confirmed this by his signature in the system test book T-879.
The provisions imposed by law, health and safety and occupational health regulations for the avoidance
of accidents and the protection of the environment which are generally applicable in the country in
which the system is operated supplement the Instructions for Use.
• Read the Instructions for Use carefully before commissioning the automatic swing door.
• Only use the system when it is in perfect working order. The operating conditions, inspection
and maintenance intervals stipulated by the manufacturer must be observed (section 6).
• Safety facilities (e.g. sensor technology, protecting covers) must not be removed or disabled.
• Arrange to have any faults rectified immediately by a skilled person.
2.4 Hazards and Risks
Depending on the system design and equipment, there is a residual risk of crushing, shearing and
collision with limited force in the movement area of the door leaf.
To Next Page
Loading...
Need help?
General
