Instructions for Use TORMAX 1102, 1201 T-1661 e 5
2 Safety
2.1 Responsibilities
For instructing the operator: A skilled person from a TORMAX sales partner
For operating the system: The operator or a person instructed by the operator
For maintenance and function control: The operator or a person instructed by the operator
For annual testing and approval: A skilled person authorised by the manufacturer
Skilled persons are persons who have adequate knowledge in the field of power-operated doors as a
result of their specialist training and experience and who are so familiar with the relevant health and
safety regulations, guide-lines and generally recognised codes of practice that they are able to assess
the condition of power-operated doors with regard to the safety of their operation.
Maintenance of electrical parts must be carried out by a trained electrician.
2.2 Use for the Purpose Intended
The automatic swing door is intended exclusively for use in dry premises in areas used as a pedestrian
thoroughfare and only within the specified technical data. Special techniques can also be used to attach
the drive unit to the building envelope. Technical modifications of the system must only be carried out
by skilled person. Any other use or extended use is considered to be improper and may result in danger
for body and life.
2.3 Pre-Conditions for the Operation of the System
The door system was designed, installed and checked for functionality and safety by skilled persons
prior to hand-over to the operator. The company responsible for the system’s installation instructed the
operator on the system’s use and maintenance as well dangers associated with the system operation.
The operator has confirmed this by his signature in the system test book T-879.
The provisions imposed by law, health and safety and occupational health regulations for the avoidance
of accidents and the protection of the environment which are generally applicable in the country in
which the system is operated supplement the Instructions for Use.
• ReadtheInstructionsforUsecarefullybeforecommissioningtheautomaticswingdoor.
• Onlyusethesystemwhenitisinperfectworkingorder.Theoperatingconditions,inspection
and maintenance intervals stipulated by the manufacturer must be observed (section 6).
• Safetyfacilities(e.g.sensortechnology,protectingcovers)mustnotberemovedordisabled.
• Arrangetohaveanyfaultsrectiedimmediatelybyaskilledperson.
2.4 Hazards and Risks
Depending on the system design
and equipment, there is a residual
risk of crushing, shearing and colli-
sion with limited force in the move-
ment area of the door leaf.
T1661_3
To Next Page
Loading...
Need help?
General
