Tormax iMotion 1401 Instructions For Use

Instructions for Use iMotion 1301/1301.S /1401 T-1305 e 11
5 Procedure in the Event of a Fault
Faults are evident from abnormal door behaviour and/or as a fault display on the user interface. Fault
displays on the user interface take the form of a flashing “E” or “H” followed by two figures.
H=notication>thesystemcancontinuetobeused.
E=fault>thesystemisstationary.
Some faults or notifications can be rectified by restarting the door drive with a software reset and/or
briefly disconnecting the system from the power supply.
Fault Display and Reset Using the TORMAX User Interface
See the table in section 7.1 for an overview of the fault displays.
 Browsethroughthefaultdisplayusingselectorkey1upwards
 (todisplayseveralfaults).
1. Reset the faultdisplay,pressselectorkey2(downwards)briey.
2. Software reset: press the key for 5 seconds.
Reset of the Fault with the Operating Mode Switch
Software reset in the event of a fault: change the operating mode.
Reset of the Fault by Disconnecting the Power Supply
If the system does not have a battery unit, disconnect from the power supply for about 10 seconds.
If this does not reset the fault or if it re-occurs after a short time, you must arrange for the fault to be rec-
tified by a skilled person from your TORMAX dealer. In this case note the fault number and inform the
dealer. See the last page or the service tag on the system for the dealer’s address.
T1305_5
T1305_4

Tormax iMotion 1401 Specifications

General

Brand	Tormax
Model	iMotion 1401
Category	Door Opening System
Language	English