MAINTENANCE AND CARE
Removing and Reinstalling the Bottom Plate
WARNING! To Reduce the Risk of Electrical Shock
or Injury from Moving Parts, Turn the Vacuum Off and
Remove the Battery Before Servicing or Cleaning the
Vacuum.
To Remove the Bottom Plate:
• Make sure the vacuum is turned Off.
• Remove the battery (see Removing and Reinstalling
the Battery, page 10).
• Press the handle release pedal to place the vacuum
cleaner in the at position.
• Turn the vacuum cleaner over, exposing the bottom
plate.
• Turn the two screws a quarter turn to release the
bottom plate (Fig. 1). Remove the bottom plate.
• To reinstall the bottom plate: Align the front edge of
the bottom plate into the notches inside the nozzle
(Fig. 2).
• Press the bottom plate into position until the plate
“clicks” on both sides. Tighten the two screws a
quarter turn to secure the bottom plate.
• Replace the Battery (see see Removing and Rein-
stalling the Battery, page 10).
MATERIAL
DRAWN
ISSUED
SCALE
FINISH
DATE
DATE
DO NOT SCALE
UNLESS OTHERWISE SPECIFIED
DESCRIPTION
DRAWING SIZE:C
PART NUMBER
SHEET 6 OF 8
TACONY CORPORATION CLAIMS PROPRIETARY
RIGHTS IN THE MATERIAL DISCLOSED HERE IN.
THIS DRAWING IS ISSUED FOR ENGINEERING
INFORMATION ONLY. IT MAY NOT BE REPRO-
DUCED, NOR MAY THE INFORMATION HERE IN
BE USED FOR MANUFACTURING PURPOSES
WITHOUT WRITTEN PERMISSION FROM TACONY
CORPORATION.
0.250
TACONY CORPORATION
1760 Gilsinn Lane, Fenton, MO 63026
DESCRIPTION OF CHANGE
REV
PART NUMBER
SHEET
6 OF 8
X.X .5 mm RADII X.X .5mm
X.XX .25mm X.XX .25mm
X.XXX .12mm MACHINE SURFACE
X.XXXX .012mm BREAK SHARP CORNERS TO .25mm MAX
0 30" COMMON TO BE CONCETRIC TO .05mm
BYECN NODATEREV
Fig. 1
Fig. 2
11
To Next Page
Loading...
Need help?
General
