7
STRAIN RELIEF
Attaching the strain relief/cord retainer to the 50’ power cord.
1. Make a loop in power cord approximately 12” from
receptacle end.
2. Slide cord loop through slot in retainer and over retainer arm.
Pull slack cord back through slot to secure. Attach retainer to handle.
EXTENSION CORD
If an extension cord is used, the wire size must be at least one size larger, (12-3) than the
power cord on the machine.
REQUIRED CLEANING CHEMICALS
Use only commercial low foam cleaning chemicals that are designed for carpet extraction.
1. General carpet extraction cleaner added to the solution tank.
2. Traffic lane per-spray usually applied with spray wand.
3. Defoamer only goes into the recovery tank.
CAUTION: Use as directed. Do not over use the cleaning chemicals.
To Next Page
Loading...
