10
BRUSH SELECTION
RECOMMENDED BRUSH
Brush must be chosen depending on type of floor and dirt to be removed. The
employed material and the bristle diameter are the elements that distinguish
different types of brush.
MATERIAL CHARACTERISTICS
PPL (Polypropylene) Good wear resistance. Maintains a characteristic with hot
water up to 140°F (60°C). It is not hygroscopic.
NYLON Excellent wear resistance, even with hot water over 140°F (60°C). It is
hygroscopic. It looses its physical characteristics over time.
TYNEX Nylon bristles with grains of abrasive material. Use with caution in order
not to mark the floor or ruin the polishing.
BRISTLES THICKNESS Thicker bristles are more rigid and must be used on
smooth floor or floor with small joints. On irregular floors with deep joints or
relieves, it is recommended to use softer bristles which penetrate more easily and
deeper. Please be aware that when brush bristles are worn out and therefore too
small, they become rigid and unable to penetrate and clean deeper. This may also
happen with thicker bristles creating brush vibration.
PAD HOLDER It is equipped with anchor points that permit the locking of the
abrasive pad. The pad is recommended to clean smooth floors.
CODE QTY DESCRIPTION USE
48902010 1 Brush PPL 0.3 Irregular floors with large joints.
48902020 1 Brush PPL 0.7 Smooth floors with small joints and
persistent dirt.
48902030 1 Brush PPL 0.9 Smooth floors with small joints and
persistent dirt.
48902040 1 Brush TYNEX Floors of resistant material and particularly
dirty.
48902050 1 Brush PPL 0.6 Normal floors.
48902060 1 Brush 5-mix For all types of floors.
48802010 1 Pad holder + center
lock green
For pads of 20”, for smooth surfaces
cleaning.
To Next Page
Loading...
Need help?
General