23
OPERATION
OVERFLOW SYSTEM
In order to avoid serious damages to the suction motor, the machine is equipped with a float
that intervenes when the recovery tank is full. When this happens, it is necessary to empty the
recovery tank. Hold the exhaust hose of the machine. Take off the plug and empty the recovery
tank into appropriate containers, according to the standard norms.
MACHINE STOP AFTER CLEANING OPERATION
BREAK WASHING MODE
IN AUTOMATIC OR MANUAL WORKING MODE:
1. At the end of the washing cycle, keeping the button (1) pressed, the functioning of BREAK
WASHING is chosen.
2. When the mode is on, BREAK WASHING is shown on the display.
This way, automatically, the brushes lift, the solenoid valve shuts down and it is possible to
finish the drying operation for a total time of about 15 seconds, afterwards the suction stops.
NOTE: all these phases are carried out with the machine operating, so that the squeegee can dry
the interested cleaning area from the “drying phase of the brushes” and furthermore can dry the
suction hose of its dirty water.
At any time it is possible to interrupt the procedure BREAK WASHING by stopping the drive.
During the BREAK WASHING, if the drive pedal is released for more than 3 seconds the machine
will automatically switch to manual mode (MAN).
The mode (BREAK WASHING) is specific for the transfer at the end of the cleaning operation.
To Next Page
Loading...
Need help?
General