27
WEEKLY MAINTENANCE
REAR SQUEEGEE RUBBER CHECK
Check the squeegee rubber wearing and eventually turn it or replace it.
For the replacement it is necessary:
1. Take off the squeegee (see chapter “CLEANING THE SQUEEGEE”).
2. Unlock the squeegee blade lock (1).
3. Take off the rubber to turn it around or replace it.
To put back the squeegee just repeat these operations backwards.
CLEANING THE SQUEEGEE HOSE
Weekly or in case of insufficient suction, it is necessary to check that the squeegee hose is not
obstructed. Eventually, to clean it, proceed as follows:
1. With the brush base lifted, rotate the squeegee on one side.
2. With the squeegee in such position, take off the squeegee hose coupling (1).
Do not wash the hose that goes from the suction motor to the recovery tank.
CLEANING THE OUTER FILTER AND THE SOLUTION TANK
Take the machine to the place assigned for the detergent solution draining.
1. Unscrew the filter cap (1) and take the filter out.
2. Wash the filter components with a water jet.
Once finished, close the valve, reassemble the filter and replace the tank cap.
MAINTENANCE
To Next Page
Loading...
Need help?
General