INSTALLATION − DECO 20a / DEC0 26a / DECO 20e / DECO 26e
300561 en − 05/08 Chap. 1.3 /2
1.3 BARFEEDING REQUIREMENTS
BARFEEDING DESCRIPTION
− For regular use, your DECO 20a / DECO 26a lathe must be equipped with
a stock tube / feeder with pusher.
− The tube / feeder is a unit independent of the lathe and has its own
controls.
− The control panel with manual controls of the tube / feeder is ergonomi-
cally arranged to conform to your DECO 20a / DECO 26a.
Δ Caution !
For impeccable operation of the BARFEEDER−LATHE assembly
TORNOS have issued instructions with the characteristics & functions
required for the feeder−lathe interface. The instructions are entitled :
INTERFACE SPECIFICATIONS FOR STOCK TUBE OR BARFEEDER
These specifications must be strictly complied with to avoid malfunc-
tioning of the bar feeding system, which might be imputed to the lathe.
TORNOS declines any liability whatsoever, should a damage or acci-
dent be imputed to a tube / feeder which do not conform to the said
specifications &/or standards in force.
BARFEEDER LOCATION / INSTALLATION
− See your instructions: INTERFACE SPECIFICATIONS FOR INSTALLA-
TION OF STOCK TUBE OR BARFEEDER
− See also Para.: Connecting Barfeeder and Chip Conveyor, below.
To Next Page
Loading...
