INSTALLATION − DECO 20a / DEC0 26a / DECO 20e / DECO 26e
300561 en − 05/08 Chap. 2.3.1 /1
2. UNPACKING − CLEANING
2.1 PACKING LATHE FOR TRANSPORT
What to do ? Notes
− Pack in a case ...
or
− Pack on a board ...
... for overseas or special trans-
ports.
... for continental transport.
Note : The invoiced packing items are property of the customer.
2.1.1 Handling Equipment
No handling equipment is provided for single-spindle automatics.
2.2 UNPACKING LATHE
Note :
Whenever you move the lathe about, proceed according to the
TRANSPORT INFO Sheet 300551 included in the machine’s docu-
mentation.
What to do ? Notes
− Pull out nails from the cover and
then from the walls of the case.
− Remove the vacuum-packing
plastic.
− Remove the wooden wedges
and ropes ...
... that hold various items.
2.3 CLEANING LATHE
2.3.1 Cleaning Lathe after Unpacking
Note :
For certain destinations the machine is rust-protected.
What to do ? Notes
− Wash carefully with gasoline or
petroleum-soaked cloth all rust-
protected surfaces.
Δ Attention !
Wash on well ventilated prem-
ises only to avoid inhaling toxic
vapors !
Δ Caution !
Do not damage or disrupt any-
thing.
Δ Avoid using compressed air and
substances that could damage
plastic materials.
To Next Page
Loading...
