Toro 03678 - Page 14

g375689
Figure13
1.Hairpin
2.Removethe2angelocknuts(3/8inch)and2
carriagebolts(3/8x1-1/4inches)thatsecure
theturf-compensatorbrackettothecutting-unit
frame(Figure14).
g375690
Figure14
1.Carriagebolt(3/8x1-1/4
inches)
3.Flangelocknut(3/8inch)
2.Turf-compensatorbracket
3.Alignthestudsoftherighthoseguidewith
theholesinthecutting-unitframeandthe
turf-compensatorbracket(Figure15).
Note:Ensurethatthesupportloopofthe
hoseguidealignstowardthecenterlineofthe
machine.
g375688
Figure15
1.Stud(hoseguide)3.Flangelocknut(3/8inch)
2.Turf-compensatorbracket
4.Inboard
4.Assemblethehoseguideandturf-compensator
brackettothecutting-unitframewiththe2ange
locknuts(3/8inch).
5.T orquethelocknutsto37to45N∙m(27to33
ft-lb).
PositioningtheTurfCompensating
Spring
CuttingUnit2
g379514
Figure16
1.Cuttingunit15.Cuttingunit5
2.Cuttingunit2
6.Reelmotor
3.Cuttingunit3
7.Weight
4.Cuttingunit4
1.Ifthehairpinisinstalledintherearholeofthe
compensation-springrod—removethehairpin
andinsertitintheholenexttothebracket
(Figure17).
14