Toro 03781 - Checking the Interlock Switches

Fuel (continued)
Adding Fuel
G423841
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Clean the area around the fuel-tank cap
and remove the cap.
3. Fill the tank until the level is to the bottom of
the filler neck
with the specified fuel.
4. Install the fuel-tank cap tightly.
Note: If possible, fill the fuel tank after each
use. Filling the fuel tank minimizes
condensation inside the tank.
Checking the Interlock Switches
CAUTION
If safety interlock switches are disconnected or damaged, the machine could operate
unexpectedly, resulting in minor or moderate injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches daily and replace any damaged
switches before operating the machine.
IMPORTANT
If your machine fails any of the interlock switch checks, contact your authorized Toro
distributor.
Preparing the Machine
1. Drive the machine slowly to an open area.
2. Lower the cutting units, shut off the engine, and engage the parking brake.
Checking the Traction Pedal Start-Interlock
1. Sit in the operator’s seat and engage the parking brake.
2. Press the PTO switch to the D
ISENGAGE position.
Operation: Before Operation Page 5–3 3466-706 A