Driving the Machine in Transport Mode
G468222
1. Press the PTO switch to the DISENGAGE
position.
2. Move the lower mow/raise control lever
backward to raise the cutting units (transport
position).
G423893
3. Move the lever for the mow-speed limiter
backward to the TRANSPORT position.
4. Press the traction pedal to drive the machine.
IMPORTANT
Be careful when driving between objects so that you do not accidentally damage the
machine or cutting units. Use extra care when operating the machine on slopes. Drive
slowly and avoid sharp turns on slopes to prevent a rollover.
Adjusting the Cutting-Unit Counterbalance
Rear Cutting Units
CAUTION
The springs are under tension, and adjusting them could result in minor or moderate
personal injury.
Use caution when adjusting the springs.
Adjust the amount of counterbalance force applied to the rear cutting-units to help
compensate for different turf conditions, and to maintain a uniform height of cut in rough
conditions or in areas of thatch buildup.
Operation: During Operation Page 5–15 3466-706 A
To Next Page
Loading...
