Toro 03952 - Priming the Fuel System

Cleaning the Fuel-Pickup Tube Screen (continued)
G415057
5. Assemble the hose onto the fittings of
the fuel sender, and secure the hoses to the
fittings with the clamps
.
G415056
6. Plug the connector of the fuel-sender harness
into the connector of the machine wire
harness
.
G415055
7. Install the fuel-sender cover to the fuel tank
using the 5 screws .
Priming the Fuel System
Prime the fuel system after the following scenarios:
• Replacing the fuel filter.
• Draining the water separator after each use or daily.
• Running out of fuel.
• Replacing a fuel hose or open the fuel system for any reason.
To prime the fuel system, perform the following steps:
Maintenance: Fuel System Maintenance Page 6–22 3464-482 A