Toro 03952 - Positioning the Turf Compensating Spring

Installing the Hose Guide (continued)
G410311
3. Align the studs of the right hose guide with
the holes in the cutting-unit frame and the turf-
compensator bracket
.
Note: Ensure that the support loop of the hose
guide aligns toward the center
of the
machine.
4. Assemble the hose guide and turf-
compensator bracket to the cutting-unit frame
with the 2 flange locknuts (3/8 inch)
.
5. Torque the locknuts to 37 to 45 N∙m (27 to 33
ft-lb).
Positioning the Turf Compensating Spring
Cutting Unit 2
G410999
Cutting unit 1
Cutting unit 2
Cutting unit 3
Cutting unit 4
Cutting unit 5
Reel motor
Weight
G410292
1. If the hairpin is installed in the rear hole of
the compensation-spring rod, remove the
hairpin and insert it in the hole next to the
bracket.
Setup: Installing the Cutting Units Page 3–6 3464-482 A