Automotive-Style Throttle
Note: This machine does not have a lever or switch to control the engine speed.
When the PTO is engaged to start spinning the cutting units, the machine automatically
changes the engine speed to high idle and stays there until the cutting units are disengaged.
When the PTO is not engaged, the throttle on the machine depends on the position of the
traction pedal, just like the throttle on a car.
Key Switch
G453721
Off
On/preheat
Start
Lower Mow/Raise Control Lever
G453725
Lower the cutting units—Engage
the PTO first for cutting units to spin
(Mow mode).
Raise the cutting units—Disengage
the PTO first for cutting units to stop
spinning (Transport mode).
Note: To partially raise the cutting
units to the turnaround position, briefly
pull the lever backward.
3464-482A Page 4–2 Product Overview: Controls
To Next Page
Loading...
