Toro 20073 - Charging the Battery; Replacing the Fuse

Figure 26
4. Slo wl y pour oil into the oil fill tube until the oil lev el
reac hes the Full line on the dipstic k ( Figure 27 ). Do not
o v erfill. (Max. fill: 20 oz., type: SAE 30W deterg ent
oil with an API ser vice classification of SF , SG , SH, SJ ,
SL, or higher .)
Figure 27
5. Install the dipstic k securely .
6. Dispose of the used oil properly at a local recycling
center .
Charging the Battery
Models 20074 and 20074A onl y
Warning
CALIFORNIA
Pr oposition 65 W ar ning
Batter y posts, ter minals, and r elated accessories
contain lead and lead compounds, chemicals kno wn
to the State of Calif or nia to cause cancer and
r epr oducti v e har m. W ash hands after handling .
Charg e the batter y for 24 hours initially , then monthly
(ev er y 25 star ts) or as needed. Alw a ys use the c harg er in a
sheltered area and c harg e the batter y at room temperature
(70° or 22° C) whenev er possible .
1. Connect the c harg er to the mo w er wire har ness located
belo w the ignition k ey ( Figure 28 ).
Figure 28
2. Plug the c harg er into a w all outlet.
Note: W hen the batter y no long er holds a c harg e ,
recycle or dispose of the lead-acid batter y according to
local codes .
Replacing the Fuse
Models 20074 and 20074A onl y
If the batter y does not c harg e or the engine does not r un
with the electric star ter , the fuse ma y be blo wn. R e place it
with a 40-amp plug-in type fuse . R efer to Installing the Fuse .
17