Storage
Store the mo w er in a cool, clean, dr y place .
Preparing the Mower for
Storage
Gasoline v apor s can explode.
• Do not stor e gasoline mor e than 30 days.
• Do not stor e the mo w er in an enclosur e near an
open flame.
• Allo w the engine to cool bef or e storing it.
1. On the last refueling of the year , add fuel stabilizer to
the fuel as directed b y the engine man ufacturer .
2. Dispose of any un used fuel properly . R ecycle it
according to local codes , or use it in y our automobile .
Note: Old fuel in the fuel tank is the leading cause of
hard star ting . Do not store fuel without stabilizer more
than 30 da ys , and do not store stabilized fuel more than
90 da ys .
3. R un the mo w er until the engine stops from r unning
out of fuel.
4. Prime the engine and star t it ag ain.
5. Allo w the engine to r un until it stops . W hen y ou can no
long er star t the engine , it is sufficiently dr y .
6. Disconnect the wire from the spark plug and connect
the wire onto the retaining post.
7. R emo v e the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole , and pull the star ter rope slo wly
sev eral times to distribute oil throughout the cylinder to
prev ent cylinder cor rosion during the off-season.
8. Loosely install the spark plug .
9. Tighten all n uts , bolts , and screws .
10. Charg e the batter y for 24 hours , then unplug the batter y
c harg er an store the mo w er in an unheated area. If y ou
m ust store the mo w er in a heated area, y ou m ust c harg e
the batter y ev er y 90 da ys (models 20074 and 20074A
only).
Folding the Handle
F olding or unf olding the handle impr oper l y can
dama ge the ca bles, causing an unsafe operating
condition.
• Do not dama ge the ca bles when f olding or
unf olding the handle.
• If a ca ble is dama ged, contact an Authoriz ed
Ser vice Dealer .
1. R emo v e the ignition k ey (models 20074 and 20074A
only).
2. Loosen the handle knobs until y ou can mo v e the upper
handle freely .
3. F old the upper handle forw ard as sho wn in Figure 35 .
Important: R oute the ca bles to the outside of the
handle knobs as y ou f old the upper handle.
Figure 35
4. T o unfold the handle , rev erse the ste ps abo v e .
Removing the Mower from
Storage
1. R emo v e the spark plug and spin the engine rapidly using
the star ter to blo w the ex cess oil from the cylinder .
2. Install the spark plug and tighten it with a tor que
wrenc h to 15 ft-lb (20 N ⋅ m).
3. Charg e the batter y for 24 hours (models 20074 and
20074A only).
4. Connect the wire to the spark plug .
20
To Next Page
Loading...
