Toro 25450A - Checking the Coolant Level in the Reservoir

Figure24
1.Dipstick2.Dipsticktube
Figure25
5.Insertthedipstickfullyintothedipsticktube,then
removethedipstick(Figure24).
6.Readtheoillevelonthedipstick(Figure25).
Note:Theoillevelonthedipstickshouldbebetween
theH(high)markandL(low)mark.
•Iftheoillevelistoolow,slowlypourasmall
amountofthespeciedoilintotheoil-llerneck
(Figure70)andwait3minutes;refertostep1in
FillingtheEnginewithOil(page49).
Important:Donotoverlltheenginewithoil.
•Iftheoillevelistoohigh,draintheexcessoiluntil
youobtainthecorrectoillevelonthedipstick;
refertoDrainingtheEngineOil(page48).
7.Repeatsteps4through6untiltheoilleveliscorrect.
8.Installthedipstickandoil-llcapsecurely.
9.Installtheleft-sidepanel;refertoInstallingtheSide
Panels(page47).
CheckingtheCoolantLevelin
theReservoir
ServiceInterval:Beforeeachuseordaily
Iftheengineoverheatwarningisdisplayedonthecontrol
panel,checkthecoolantlevelinthereservoirandaddcoolant
ifitislow .Alsoinspecttheenginecompartmentaroundthe
radiatorandclearawayanyobstructionstoairow.
1.Parkthemachineonalevelsurface,stoptheengine,
andremovetheignitionkey.
2.Allowtheenginetocool.
3.Removetheleftsidepanel;refertoRemovingtheSide
Panels(page46).
4.Checkthecoolantlevelinthereservoir(Figure26).
2
1
g024979
Figure26
1.Reservoir
2.Coolantlevel(halfway
betweentheAddandFull
marks)
Note:Ensurethatthecoolantlevelisbetween1/4
and3/4ofthewayupinthesightglass(Figure26).
5.Addthespeciedcoolantuntilthecoolantlevelis
between1/4and3/4ofthewayupinthesightglass.
Note:Ensurethatthecoolantsolutionisthoroughly
mixedbeforellingthereservoir.
6.Installtheleftsidepanel;refertoInstallingtheSide
Panels(page47).
26