Toro 30252 - Maintenance; Recommended Maintenance Schedule

20
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
Each Use
• Oil—check level
• Safety Interlock System—test
• Brake—test
• Engine—clean the cooling system
• Mower housing—clean
After first 8 hours • Oil—change
8 Hours
• Wheel bearings—grease
1
• Cutting blade—check for wear, cracks, or other damage
• Blade spindle bearing—grease
• Mower housing—clean
25 Hours • Foam air cleaner—service
1
50 Hours
• Belts—check for wear or cracks
• Tires—check pressure
100 Hours
• Oil—change
1
• Paper air cleaner—replace
1
• Electric clutch—adjust
• Engine—clean the cooling system
200 Hours
• Oil filter—change
• Transmission couplings—grease
1
• Spark plug—check
• Fuel filter—replace
Storage Service
• Perform all procedures listed above
• Chipped surfaces—paint
1
More often in dusty, dirty conditions
Important Refer to your engine operator’s manual for additional maintenance procedures.
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.