Toro 30252 - Page 38

38
Problem Corrective ActionPossible Causes
Abnormal vibration.
1. The blade is bent or
unbalanced.
1. Install a new blade.
2. The blade mounting bolt is
loose.
2. Tighten the blade mounting
bolt.
3. The engine mounting bolts are
loose.
3. Tighten the engine mounting
bolts.
4. There is a loose engine pulley,
idler pulley, or spindle pulley.
4. Tighten the appropriate pulley.
5. The engine pulley is damaged. 5. Contact your Authorized
Service Dealer.
6. The blade spindle is bent. 6. Contact your Authorized
Service Dealer.
Machine does not drive.
1. The shift lever is in Neutral. 1. Move shift lever to a drive gear
position.
2. The traction belt is worn, loose,
or broken.
2. Change the traction belt.
3. The traction belt is off the
pulley.
3. Change the traction belt.
Uneven cutting height.
1. The blade is dull. 1. Sharpen the blade.
gg
2. The blade is bent. 2. Install a new blade.
3. The mower is not level. 3. Level the mower from
side-to-side and front-to-rear.
4. The underside of the mower is
dirty.
4. Clean the underside of the
mower.
5. The traction unit tire pressure is
incorrect.
5. Adjust the tire pressure.
6. The blade spindle bent. 6. Contact your Authorized
Service Dealer.
Blade does not rotate.
1. The mower drive belt is worn,
loose, or broken.
1. Install a new mower drive belt.
2. The mower drive belt is off the
pulley.
2. Install the mower drive belt and
check the adjusting shafts and
belt guide for correct position.