Figure 22
1. Damper link
Figure 23
Adjusting the Skids
T he skids should be mounted in the lo w er position
when operating in height of cuts g reater than
2-1/2 inc hes (64 mm) and in the higher position
when operating in height of cuts lo w er than 2-1/2
inc hes (64 mm).
Adjust the skids b y remo ving the flang e bolt and
n uts , positioning them as desired, and installing
the fasteners ( Figure 24 ).
Figure 24
1. Skid
Adjusting the Cutting Unit Rollers
T he cutting unit rollers should be mounted in
the lo w er position when operating in height of
cuts g reater than 2-1/2 inc hes (64 mm) and in the
higher position when operating in height of cuts
lo w er than 2-1/2 inc hes (64 mm).
1. R emo v e the bolt and n ut securing the g ag e
wheel to the cutting unit brac k ets ( Figure 25 ).
Figure 25
1. Gage wheel
2. Align the roller and spacer with the top holes
in the brac k ets and secure them with the bolt
and n ut.
Correcting Mismatch Between Cutting
Units
Due to differences in g rass conditions and the
counterbalance setting of the traction unit, it is
advised that g rass be cut and appearance c hec k ed
before for mal cutting is star ted.
1. Set all cutting units to the desired height of cut;
refer to Adjusting the Height of Cut table in
Specifications , pag e 18 .
26
To Next Page
Loading...
