Toro 30630 Groundsmaster 328-D - Checking the Tire Pressure; Checking the Torque of the Front Wheel Nuts; Greasing the Traction Unit; Install Rear Weight

19
6. Raise front of lift arm until hole in movable end of
cylinder lines up with holes in lift arm brackets. Use
caution as lift arm is spring-loaded. Hold parts together
with cylinder pin, spring pin, and cotter pin. Cotter pin
must be to the outside.
1
2
3
4
5
Figure 13
1. Jam nut
2. 2 x 4 in. (51 x 102 mm)
block
3. Left-hand push arm
4. Ball joint mount
5. 2-3/8 in. (60 mm)
7. Install implement; refer to implement Operator’s
Manual for proper installation procedures.
Checking the Tire Pressure
The tires are over-inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure
in the front and rear tires is 21 psi (145 kPa).
Checking the Torque of the
Front Wheel Nuts
Failure to maintain proper torque of the front
wheel nuts could result in failure, loss of wheel, or
personal injury.
Torque the front wheel nuts to 45–55 ft.-lb.
(61–75 Nm) after 1–4 hours of operation and
again after 10 hours of operation. Torque every
250 hours thereafter.
Warning
Greasing the Traction Unit
Before the machine is operated, it must be greased to assure
proper operating characteristics; refer to Lubrication
Maintenance. Failure to grease the machine will result in
premature failure of critical parts.
Note: After setup has been completed, remove protective
edging (used for shipping) from fenders.
Install Rear Weight
To comply with ANSI/OPEI B71.4–1999 Standard, rear weight must be added to rear of traction unit. Use chart below to
determine weight requirements. Order parts from your local Authorized Toro Distributor.
Note: A rear weight kit, part no. 24–5780 is supplied with Model No. 30630.
Cutting Unit
Description
Rear Weight
Required
Weight Part
Number
Weight Description Qty.
72″ Side Discharge
(Model No. 30722)
70 lb. 24–5780 Rear Weight Kit (includes two 35 lb. weights and
mounting hardware)
1
72″ Rear Discharge
(Model No. 30710)
70 lb. 24–5780 Rear Weight Kit (includes two 35 lb. weights and
mounting hardware)
1
Guardian 72″ Re-
cycler (Model No.
30716)
70 lb. 24–5780 Rear Weight Kit (includes two 35 lb. weights and
mounting hardware)
1
72” Flex Deck
(Model 30799)
210 lb. 24–5780 Rear Weight Kit (includes two 35 lb. weights and
mounting hardware)
3