Why won't the mower deck run when the PTO switch is engaged on my Toro 31051 Lawn Mower?
If the mower deck does not run when you engage the PTO switch on your Toro Lawn Mower, make sure you are sitting in the operator’s seat and that the hopper is in the fully lowered position.
What to do if the engine-oil warning light illuminates on my Toro Lawn Mower?
If the engine-oil warning light comes on in your Toro Lawn Mower, it indicates insufficient engine-oil pressure. Check the engine-oil level and add oil if necessary. If the problem persists, change the engine oil and the engine-oil filter.
What to do if the dash panel lights turn on but the starter motor doesn't turn on my Toro 31051 Lawn Mower?
If the dash panel indicator lights turn on when the key switch is in the ON position, but the starter motor doesn't turn on your Toro Lawn Mower, the battery may not be providing enough current, so charge the battery. Ensure the traction pedal is in the NEUTRAL position and that you are sitting in the operator’s seat. Also, make sure the PTO is disengaged.
Why does my Toro Lawn Mower vibrate while operating?
If your Toro Lawn Mower vibrates during operation, it could be due to unbalanced blades. Try balancing the blades, or replace them if they are damaged. Also, check for any loose bolts, such as the blade bolts, engine bolts, and frame screws, and tighten them as needed.
What to do if my Toro 31051 engine shuts off while the PTO is still engaged?
If your Toro Lawn Mower engine shuts off while the PTO is engaged, the PTO switch may be malfunctioning, so check its function. Ensure you are sitting in the operator's seat. Also, make sure the hopper is closed and lowered. Finally, check that the parking brake is disengaged, especially if the traction pedal is pressed down.
What to do if the cut is uneven with my Toro 31051 Lawn Mower?
If you notice an uneven cut and insufficient collection with your Toro Lawn Mower, several factors could be the cause. Make sure the tires are properly inflated and adjust the mower deck to be parallel to the ground. Check if the blades are mounted correctly and sharpen or replace them if necessary. Also, adjust the PTO belt tension. If your travel speed is too fast for the grass height, slow down. Ensure that the chute is not blocked by cleaning it and verify that the maximum engine speed is 3000 rpm. Additionally, clean the grass-catcher screen.
Why won't my Toro 31051 Lawn Mower start, even though the starter motor turns?
If the starter motor turns but the engine doesn't start on your Toro Lawn Mower, check the fuel-tank level and refill if needed. Inspect and replace the fuel filter if necessary. Make sure the vent on the fuel-tank cap isn't blocked. Allow the glow-plug warning light to switch off, or shut off the engine and turn the key to the ON/PREHEAT position for a second glow cycle.
What to do if the starter motor turns, but the engine does not start on my Toro 31051?
If the starter motor turns but the engine doesn't start on your Toro Lawn Mower, check the fuel-tank level to ensure fuel is flowing through the system. Inspect and replace the fuel filter if necessary. Make sure the vent on the fuel-tank cap isn't blocked. If the engine is cold, wait for the glow-plug warning light to switch off, or shut off the engine and turn the key to the ON/PREHEAT position for a second glow cycle.
General| Model | 31051 |
|---|---|
| Engine Type | 4-Cycle |
| Start Type | Recoil |
| Deck Material | Steel |
| Drive System | Rear Wheel Drive |
| Engine | Briggs & Stratton |
| Starting System | Recoil |
| Drive Type | Self-Propelled |
| Fuel Capacity | 0.5 quarts |
| Oil Capacity | 20 oz |
| Wheel Size | 8 inches |
| Cutting Height | 1.0 - 4.0" / 2.5 - 10.2 cm |
To Next Page
