Toro 38051 - Safety and Instruction Decals; Assembly; Loose Parts

6
Safety and Instruction Decals
Safety and instruction decals are easily visible to the operator and are located near any area
of potential danger . Replace any decal that is damaged or lost.
On Auger/
Impeller Housing
(Part No. 53–7670)
On Control Panel
(Part No. 100–3332,
model 38051 only)
On Chute Control Bracket
(Part No. 63–3510)
On Discharge
Chute
(Part No. 94–8097)
On Control Panel
(Part No. 99–3214)
On Engine
(T ecumseh Part No. 371 19)
Next to Primer
(T ecumseh Part No. 36501)
By Choke
(T ecumseh
Part No. 34418)
Between Ignition and
Throttle
(T ecumseh Part No. 35063)
On Control Panel
(Part No. 100–3333,
model 38064 only)
On Control Panel
(Part No. 100–3437,
model 38072 only)
Assembly
Note: Determine the left and right sides of the snowthrower by standing in the normal operating position.
Loose Parts
DESCRIPTION QTY. USE
Capscrews and curved washers 4 Installing the handle
Cotter pin
Flat washer
1
1
Installing the speed selector rod
Clevis pin
Cotter pin
Flange nut
Locking flange nut
1
1
1
1
Installing the auger/impeller and traction drive
control rod