Note: If y ou do not ha v e a tor que wrenc h, tighten
the plug fir mly .
Adjusting the Discharge Chute
Latch
If the disc harg e c hute does not loc k into the desired
position or does not unloc k so that y ou can mo v e it to
another position, adjust the disc harg e c hute latc h.
1. R emo v e the fastener on the g ear co v er ( Figure 46 ), lift
the front of the co v er up , and slide it bac k and out of
the w a y .
Figure 46
2. Loosen the bolt on the cable clamp ( Figure 47 ).
Figure 47
1. Cable conduit 2. Cable clamp
3. Grasp the cable conduit and mo v e it to w ard the front of
the mac hine until the disc harg e c hute latc h fully eng ag es
the g ear teeth ( Figure 47 and Figure 48 ).
Figure 48
1. Discharge chute latch 2. Gear teeth
Note: T he latc h is spring loaded and will naturally
mo v e into the teeth of the g ear ( Figure 48 ).
4. R emo v e any slac k in the cable b y pulling the cable
conduit rearw ard.
5. Tighten the bolt on the cable clamp .
6. Install and secure the g ear co v er .
Replacing the Drive Belts
If the aug er/impeller dri v e belt or the traction dri v e belt
becomes w or n, oil-soak ed, or otherwise damag ed, g o to
www .T oro .com for additional ser vice infor mation or ha v e
an A uthorized Ser vice Dealer re place the belt.
18
To Next Page
Loading...
