EasyManua.ls Logo

Toro 74353 - Replacing the Fuel Filter; Electrical System Maintenance

Toro 74353
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 30
1. Hose clamp 3. Filter
2. Fuel line
5. Pull the fuel line off of the fuel filter ( Figure 30 ).
6. Open the fuel shut-off v alv e . Allo w g asoline to
drain into a g as can or drain pan.
Note: No w is the best time to install a new
fuel filter because the fuel tank is empty .
7. Install the fuel line onto the fuel filter . Slide
the hose clamp close to the fuel filter to secure
the fuel line ( Figure 30 ).
Replacing the Fuel Filter
R e place the fuel filter after ev er y 100 operating
hours or yearly , whic hev er occurs first.
Nev er install a dir ty filter if it is remo v ed from the
fuel line .
1. P ark the mac hine on a lev el surface and
diseng ag e the blade control switc h.
2. Mo v e the motion control lev ers to the brak e
position, stop the engine , remo v e the k ey , and
w ait for all mo ving par ts to stop before lea ving
the operating position.
3. Close the fuel shut-off v alv e located under the
front of the fuel tank.
4. Squeeze the ends of the hose clamps tog ether
and slide them a w a y from the filter ( Figure 31 ).
Figure 31
1. Hose clamp 3. Filter
2. Fuel line
5. R emo v e the filter from the fuel lines .
6. Install a new filter and mo v e the hose clamps
close to the filter ( Figure 31 ).
7. Open the fuel shut-off v alv e .
Electrical System
Maintenance
Warning
CALIFORNIA
Pr oposition 65 W ar ning
Batter y posts, ter minals, and r elated
accessories contain lead and lead
compounds, chemicals kno wn to the State of
Calif or nia to cause cancer and r epr oducti v e
har m. W ash hands after handling .
26

Related product manuals