Toro 74915 Z Master G3 - Page 56

6.Inserttheheightadjustmentpinintothe3inch(7.6
cm)cuttingheightlocation.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthelevel
surfacetothefronttipoftheblade(PostionA).
Themeasurementshouldread3inches(7.6mm)
(
Figure87).
Figure87
1.3inches(7.6cm)atAis
correct
3.Measureherefromthe
bladetiptohardsurface
2.31/4inches(8.3cm)atB
iscorrect
4.MeasureatAandBon
bothsides
10.Fine-tunetheadjustmentnutonthefrontdecklift
assemblybyturningit(Figure88).
Toincreasetheheight,turntheadjustmentnut
clockwise;todecrease,turncounterclockwise.
G012430
1
2
2 1
3 4
Figure88
1.Adjustmentnut3.Reardeckadjustment
2.JamNut4.Frontdeckadjustment
11.Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,the
singlepointadjustmentcanbeutilizedtogainmore
adjustment.
12.Toadjustthesinglepointsystem,loosenthetwo
boltsatthebottomoftheheightofcutplate.Refer
toFigure89.
Figure89
1.Boltsatthebottomoftheheight-of-cutplate
56