Why does the starter not crank on my Toro 74923?
If the starter on your Toro Lawn Mower does not crank, ensure that the blade control switch (PTO) is disengaged. Also, set the parking brake, ensure that the drive levers are in the neutral lock position, and sit on the seat. You may also need to charge the battery, check the electrical connections for good contact, or replace the fuse. If problems persist, contact an Authorized Service Dealer.
Why won't my Toro 74923 engine start, starts hard, or fails to keep running?
If your Toro Lawn Mower engine will not start, starts hard, or fails to keep running, fill the fuel tank, open the fuel shutoff valve and add oil to the crankcase. Ensure that the throttle control is midway between the “SLOW” and “FAST” positions. Also, replace the fuel filter, clean or replace the air cleaner element, check the seat switch indicator (replace the seat if needed), check the electrical connections for good contact (clean the connector terminals thoroughly with electrical contact cleaner, apply dielectric grease, and reconnect), clean, adjust, or replace the spark plug and check the spark plug wire connection. If problems persist, contact an Authorized Service Dealer.
Why Toro 74923 blades do not rotate?
If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken mower deck belt; in this case, install a new deck belt. Another possibility is that the mower deck belt is off the pulley; reinstall it and check the idler pulley, idler arm, and spring for correct position and function. Also, check the pump drive belt for wear, looseness, or breakage, and adjust the belt tension or install a new belt. Finally, inspect the idler spring and replace it if it's broken or missing.
What causes my Toro 74923 Lawn Mower engine to lose power?
A loss of power in your Toro Lawn Mower engine can stem from several causes. The engine load might be excessive, so reduce the ground speed. Check the air cleaner element; if it's dirty, clean it. Ensure the oil level in the crankcase is sufficient by adding oil if needed. Clear any obstructions from the cooling fins and air passages above the engine, and clean or replace the fuel cap if the vent hole is plugged. Also, replace the fuel filter if it's dirty. For issues like dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
What to do if my Toro 74923 Lawn Mower machine vibrates abnormally?
If your Toro Lawn Mower is vibrating abnormally, it could be due to: * Bent or unbalanced cutting blade(s); install new cutting blade(s). * A loose blade mounting bolt; tighten the blade mounting bolt. * Loose engine mounting bolts; tighten the engine mounting bolts. * A loose engine pulley, idler pulley, or blade pulley; tighten the appropriate pulley.
What causes abnormal vibrations in my Toro 74923 Lawn Mower?
If your Toro Lawn Mower vibrates abnormally, try the following: 1. Install new cutting blade(s). 2. Tighten the blade mounting bolt. 3. Tighten the engine mounting bolts. 4. Tighten the appropriate pulley.
What to do if my Toro Lawn Mower pulls left or right?
If your Toro Lawn Mower pulls to the left or right (with levers fully forward), it could be due to: * The tracking needs adjustment; adjust the tracking. * Incorrect tire pressure in drive tires; adjust tire pressure in the drive tires.
What to do if the malfunction Indicator Light (MIL) comes on in my Toro 74923 Lawn Mower?
If the malfunction indicator light (MIL) comes on in your Toro Lawn Mower, try the following: Turn the engine off and let it cool. Use new gas. Open the fuel shut-off valve. Make sure that the air cleaner and precleaner are clean, and replace them if necessary. Charge or replace the battery. Ensure that a good 12 volt battery is being used and is fully charged. Check and replace any blown fuses. If the problem persists, it is best to contact an Authorized Service Dealer.
Why is my Toro Lawn Mower not driving?
If your Toro Lawn Mower isn't driving, the bypass valves might not be closed tight, so tighten them. Alternatively, the pump belt might be worn, loose, or broken; in this case, change the belt. Another possibility is that the pump belt is off a pulley, so change the belt. The idler spring could also be broken or missing, so replace the spring. Lastly, the hydraulic fluid level might be low or too hot, so add hydraulic fluid to the reservoirs or let it cool down.
How to fix a Toro 74923 when the starter does not crank?
If the starter on your Toro Lawn Mower doesn't crank, here are some things to check: 1. Move the blade control switch (PTO) to disengaged. 2. Set the parking brake. 3. Ensure that the drive levers are in the neutral lock position. 4. Sit on the seat. 5. Charge the battery. 6. Check the electrical connections for good contact. 7. Replace the fuse.
General| Drive Type | Self-Propelled |
|---|---|
| Deck Material | Steel |
| Washout Port | Yes |
| Drive System | Rear Wheel Drive |
| Oil Capacity | 20 oz |
| Cutting Width | 22" (56 cm) |
To Next Page
