Toro 74953 - Controls System Maintenance; Adjusting the Control Handle Position

7.Removethebeltfromthehydraulicunitdrivepulleys
andtheenginepulley
8.Installthenewbeltaroundenginepulleyandthetwo
drivepulleys.
9.Usingaratchetinthesquareholeintheidlerarm,
installtheidlerspringtotheframe(Figure76).
10.Installthemowerbelt.RefertoReplacingtheMower
Belt(page49).
ControlsSystem
Maintenance
AdjustingtheControlHandle
Position
Therearetwoheightpositionsforthecontrollevers;highand
low .Removetheboltstoadjusttheheightfortheoperator.
1.DisengagethePTO,movethemotion-controlleversto
theneutral-lockedposition,andsettheparkingbrake.
2.Stoptheengine,removethekey,andwaitforallmoving
partstostopbeforeleavingtheoperatingposition.
3.Loosentheboltsandangenutsinstalledinthelevers
(Figure77).
4.Aligntheleversfronttorearpositionbybringthe
leverstogethertotheneutralpositionandslidethem
untiltheyarealigned,thentightenthebolts(Figure78).
Figure77
1.Bolt
3.Controllever
2.Handle4.Nut
51