Toro 74995 - Page 63

4.Temporarilyinstallajumperwireacrossthe
terminalsintheconnectorofthemainwire
harness.
5.Starttheengine.
Note:Engagetheparkingbrakeandmove
themotion-controlleversoutbeforestarting
theengine.Youdonotneedtobeintheseat
becauseofthejumperwirebeingused.Runthe
engineatfullthrottleandreleasethebrake.
6.Runthemachineatleast5minuteswiththe
motion-controlleversatfullforwardspeed
tobringthehydraulicoiluptooperating
temperature.
7.Bringthemotion-controlleversintotheNEUTRAL
position.
8.Adjustthepump-controlrodlengthsbyrotating
thedoublenutsontherodintheappropriate
directionuntilthewheelsslightlycreepin
reverse(Figure89).
g029649
Figure89
1.Doublenuts
9.Movethemotion-controlleverstotheREVERSE
position,andwhileapplyingslightpressureto
thelever,allowthereverseindicatorspringsto
bringtheleversbacktoneutral.
Note:Thewheelsmuststopturningorslightly
creepinreverse.
10.Shutoffthemachine.
11.Removethejumperwirefromwireharnessand
plugtheconnectorintotheseatswitch.
12.Removethejackstands.
13.Raisethedeckandinstalltheheight-of-cutpin.
63