Toro 74995 - Page 68

11.Fine-tunetheadjusterscrewbyturningittoget
7.6mm(3inch)height(Figure97).
Note:Toincreasetheheight,turntheadjuster
screwclockwise;todecreasetheheight,turnit
counterclockwise.
g029650
Figure97
1.Flangedlocknut3.Jamnut
2.Adjusterscrew
4.Yoke
12.Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,
loosenthe2boltsatthebottomofthe
height-of-cutplatetoadjustthesingle-point
system(Figure98).
g029651
Figure98
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow,tightenthesingle-point
adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesingle-point
adjustmentboltbyrotatingitcounterclockwise
(Figure99).
Note:Loosenortightenthesingle-point
adjustmentboltenoughtomovethe
height-of-cutplatemountingboltsatleast1/3
thelengthoftheavailabletravelintheirslots.
Thisregainssomeupanddownadjustmenton
eachofthe4decklinks.
g017036
Figure99
1.Single-pointadjustmentbolt
14.Tightenthe2boltsatthebottomofthe
height-of-cutplate(Figure98).
Note:Formostconditions,adjusttheback
bladetip4mm(1/4inch)higherthanthefront.
15.Torquethe2boltsto37to45N∙m(27to33ft-lb).
16.Onbothsidesofthedeck,measurefromthe
levelsurfacetothebacktipoftheblade(position
B)asshowninFigure96.
Note:Themeasurementshouldread8.3cm
(3-1/4inches)
17.Fine-tunetheadjusterscrewbyturningittoget
8.3mm(3-1/4inches)height(Figure97).
Note:T oincreasetheheight,turnthe
adjustmentnutclockwise;todecreasethe
height,turnitcounterclockwise.
18.Measureuntilall4sidesarethecorrectheight.
19.Tightenallthenutsonthedeck-lift-arm
assemblies.
20.Lowerthedischargechute.
68