Toro 74995 - User Manual

80 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

FormNo.3400-686RevB

ZMaster

®

Professional5000

SeriesRidingMower

with52inTURBOFORCE

®

SideDischarge

Mower

ModelNo.74995—SerialNo.316000001andUp

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3400-686*B

Table of Contents

Questions and Answers

K
Katherine RosalesSep 2, 2025
How to fix uneven cutting height on Toro 74995 Lawn Mower?
- G
  gabrielajohnsonSep 2, 2025
  To address an uneven cutting height with your Toro Lawn Mower: * Sharpen the blades if they are not sharp. * Replace bent cutting blades. * Level the mower deck from side-to-side and front-to-rear. * Clean the underside of the mower if it is dirty. * Adjust the tire pressure to the correct level. For a bent blade spindle, it is recommended to contact an Authorized Service Dealer.
M
Mark MelendezSep 2, 2025
What to do if my Toro 74995 Lawn Mower engine loses power?
- K
  kingtammySep 2, 2025
  If your Toro Lawn Mower engine is losing power, try these steps: * Reduce the ground speed if the engine load is excessive. * Clean the air-cleaner element if it is dirty. * Add oil to the crankcase if the oil level is low. * Remove any obstructions from the cooling fins and air passages. * Clean or replace the fuel cap if the vent hole is plugged. * Replace the fuel filter if it contains dirt. For issues related to dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
D
Denise GarnerSep 1, 2025
How to fix an uneven cutting height on my Toro Lawn Mower?
- T
  Travis BarnesSep 2, 2025
  If your Toro Lawn Mower is producing an uneven cutting height, try sharpening the blades, installing new cutting blades, leveling the mower deck from side-to-side and front-to-rear, cleaning the underside of the mower, or adjusting the tire pressure. If the issue persists, contact an Authorized Service Dealer.
G
Gregory MaldonadoSep 1, 2025
Why is my Toro 74995 Lawn Mower engine losing power?
- Z
  Zachary MoralesSep 1, 2025
  Your Toro Lawn Mower engine may lose power for several reasons. First, the engine load might be excessive, so reduce the ground speed. A dirty air cleaner can also cause power loss, so clean the air-cleaner element. Ensure the oil level in the crankcase is sufficient by adding oil if it's low. Lastly, check if the cooling fins and air passages above the engine are plugged and remove any obstructions.
B
Brandon JohnsonSep 1, 2025
What to do if my Toro 74995 produces an uneven cutting height?
- L
  Lisa HouseSep 1, 2025
  An uneven cutting height with your Toro Lawn Mower can result from dull or bent blades; sharpen the blade(s) or install new cutting blade(s). Also, the mower deck might not be level; level the mower deck from side-to-side and front-to-rear. A dirty mower underside can also cause this issue; clean the underside of the mower. Incorrect tire pressure could also be the cause; adjust the tire pressure.
K
kellyleeAug 31, 2025
Why does my Toro 74995 produce an uneven cutting height?
- P
  Patrick BarnettSep 1, 2025
  An uneven cutting height with your Toro Lawn Mower can be caused by several factors. The blades might not be sharp, so sharpen them. Bent cutting blades can also cause this issue, so install new ones if necessary. Ensure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower, as dirt buildup can interfere with cutting height. Adjust the tire pressure to the correct level. For a bent blade spindle, contact an Authorized Service Dealer.
R
Richard FosterAug 31, 2025
Why Toro 74995 machine does not drive?
- R
  renee78Aug 31, 2025
  If your Toro Lawn Mower isn't driving, start by checking that the bypass valves are closed tight. Inspect the pump belt for wear, looseness, or breakage, and change the belt if needed. Also, ensure the pump belt is properly on the pulley. If the idler spring is broken or missing, replace it. Finally, check the hydraulic-fluid level and add fluid to the reservoirs if it's low, or let it cool down if it's too hot.
T
Tina WhiteAug 31, 2025
Why Toro 74995 Lawn Mower engine loses power?
- L
  Lauren AndersonAug 31, 2025
  If your Toro Lawn Mower engine is losing power, consider these potential causes. First, the engine load might be excessive, so reduce the ground speed. A dirty air cleaner can also cause power loss, so clean the air-cleaner element. Additionally, check the oil level in the crankcase and add oil if it's low. Finally, ensure the cooling fins and air passages above the engine are free from obstructions.
J
Jessica SmithAug 31, 2025
Why Toro 74995 Lawn Mower starter does not crank?
- D
  david41Aug 31, 2025
  If the starter on your Toro Lawn Mower isn't cranking, there are several things to check. Ensure that the blade-control switch (PTO) is disengaged and the parking brake is engaged. Also, the motion-control levers must be in the NEUTRAL-LOCK position, and the operator must be seated. A dead battery can prevent cranking, so charge the battery. Check the electrical connections for good contact, as corrosion or looseness can cause issues. If the fuse is blown, replace it. For a worn or damaged relay or switch, contact an Authorized Service Dealer.
A
Anna BishopAug 30, 2025
What to do if my Toro 74995 Lawn Mower blades do not rotate?
- C
  Christina BeckerAug 31, 2025
  If the blades aren't rotating, the mower deck belt might be worn, loose, or broken; install a new deck belt. Also, the mower deck belt may be off the pulley; install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Check the belt tension or install a new belt if the pump drive belt is worn, loose, or broken. Replace the spring if the idler spring is broken or missing.

Toro 74995 Specifications

General

Brand	Toro
Model	74995
Category	Lawn Mower
Language	English

Related product manuals

Preview: Toro 74997

Preview: Toro 74991

Preview: 74991 Z Master Professional 5000 Series

74991 Z Master Professional 5000 Series

Preview: Toro 74952

Preview: Toro 74920

Preview: Toro 74915