What to do if the blades on my Toro Lawn Mower do not rotate?
If the blades on your Toro Lawn Mower do not rotate: 1. Install a new deck belt. 2. Install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. 3. Check the belt tension or install a new belt. 4. Replace the spring.
Why is my Toro 75967 Lawn Mower resulting in an uneven cutting height?
If mowing results in an uneven cutting height with your Toro Lawn Mower, try the following: 1. Sharpen the blade(s). 2. Install new cutting blade(s). 3. Level the mower deck from side-to-side and front-to-rear. 4. Clean the underside of the mower. 5. Adjust the tire pressure.
How to fix a Toro 75967 when the starter does not crank?
If the starter on your Toro Lawn Mower doesn't crank, here are some things to check: 1. Move the blade control switch (PTO) to disengaged. 2. Set the parking brake. 3. Ensure that the drive levers are in the neutral lock position. 4. Sit on the seat. 5. Charge the battery. 6. Check the electrical connections for good contact. 7. Replace the fuse.
Why won't my Toro Lawn Mower engine start?
If your Toro Lawn Mower engine won't start, starts hard, or fails to keep running, try the following: * Fill the fuel tank. * Open the fuel shutoff valve. * Add oil to the crankcase. * Ensure that the throttle control is midway between the 'SLOW' and 'FAST' positions. * Replace the fuel filter. * Clean or replace the air cleaner element. * Check the seat switch indicator; replace the seat if needed. * Check the electrical connections for good contact; clean the connector terminals thoroughly with electrical contact cleaner, apply dielectric grease, and reconnect. * Clean, adjust, or replace the spark plug. * Check the spark plug wire connection.
Why aren't the blades rotating on my Toro 75967?
If the blades on your Toro Lawn Mower aren't rotating, check for a damaged, worn, loose, or broken mower deck belt and install a new deck belt if needed. If the mower deck belt is off the pulley, install it back on the deck pulley and check the idler pulley, idler arm, and spring for correct position and function. Inspect the pump drive belt for wear, looseness, or breakage; check the belt tension or install a new belt. Replace the idler spring if it is broken or missing.
Why is my Toro 75967 mowing resulting in uneven cutting height?
Uneven cutting height with your Toro Lawn Mower can result from dull blades (sharpen them), bent cutting blades (install new ones), or an unlevel mower deck (level it from side-to-side and front-to-rear). Also, clean the underside of the mower if it's dirty and ensure the tire pressure is correct. If the blade spindle is bent, contact an Authorized Service Dealer.
What causes my Toro 75967 Lawn Mower engine to lose power?
A loss of power in your Toro Lawn Mower engine can stem from several causes. The engine load might be excessive, so reduce the ground speed. Check the air cleaner element; if it's dirty, clean it. Ensure the oil level in the crankcase is sufficient by adding oil if needed. Clear any obstructions from the cooling fins and air passages above the engine, and clean or replace the fuel cap if the vent hole is plugged. Also, replace the fuel filter if it's dirty. For issues like dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer.
How to fix an uneven cutting height on my Toro 75967 Lawn Mower?
To fix an uneven cutting height on your Toro Lawn Mower, start by sharpening any dull blades or replacing bent ones. Next, level the mower deck from side-to-side and front-to-rear. Clean the underside of the mower deck. Also, ensure the tire pressure is correct. If the blade spindle is bent, contact an Authorized Service Dealer.
How to fix power loss in my Toro Lawn Mower engine?
If your Toro Lawn Mower engine is losing power, first reduce the ground speed, as the engine load might be excessive. Other possible causes include a dirty air cleaner (clean it), low oil level in the crankcase (add oil), or plugged cooling fins and air passages (remove the obstruction). Also, check for a plugged vent hole in the fuel cap (clean or replace the cap) and dirt in the fuel filter (replace the filter). If the issue continues, there might be dirt, water, or stale fuel in the fuel system, and you should contact an Authorized Service Dealer.
What causes the blades on my Toro 75967 not to rotate?
If the blades on your Toro Lawn Mower aren't rotating, check these potential causes: * The mower deck belt might be worn, loose, or broken; install a new deck belt. * The mower deck belt could be off the pulley; install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. * The pump drive belt might be worn, loose, or broken; check the belt tension or install a new belt. * A broken or missing idler spring can also cause this issue; replace the spring.
General| Model | 75967 |
|---|---|
| Deck Material | Steel |
| Start Type | Recoil |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Cutting Width | 22 inches |
| Drive System | Personal Pace |
| Fuel Capacity | 0.33 gallons |
| Cutting Height | 1.0 - 4.0" / 2.5 - 10.2 cm |
To Next Page
