Toro DH 210 - Electrical System Maintenance

Figure29
1.Bulbholder
4.Slots
2.Reector
5.Terminals
3.Tab(2)
8.Pushandrotatethebulbcounterclockwiseabout
1/4turnuntilitstopsandremovethebulbfromthe
bulbholder(Figure30).
Figure30
1.Bulb3.Bulbholder
2.Metalpins
4.Slots
InstallingtheBulb
1.Alignthemetalpinsonthebaseofthebulbwiththe
slotsinthebulbholderandinsertthebaseintothe
holder(
Figure30).
2.Pushandrotatethebulbclockwiseuntilitstops.
3.Alignthetabsonthebulbholder(
Figure30)with
theslotsinthereector.
4.Insertthebulbholderintothereectorandrotateit
1/4turnclockwiseuntilitstops.
5.Connectthewireconnectorstotheterminalsonthe
bulbholder.
ReplacingtheFuse
Theelectricalsystemisprotectedbyfuses.Theyare
locatedbeneaththehood,nearthefueltank(Figure31).
Ifafusegoesout,checkthecircuitwiringforashort.
Figure31
1.Main/battery
3.Fullbagbuzzer
2.Interlock,electricclutch,
andcruisecontrol
4.Extrafuse
Toreplaceafuse,pulluptoremoveitfromthesocket.
Pushdowntoinsertit.
•Main/Battery—15amp
•Interlock,electricclutch,andcruisecontrol—10
amp
•Fullbagbuzzer—5amp
ServicingtheBattery
Alwayskeepthebatterycleanandfullycharged.Use
apapertoweltocleanthebatteryandbatterybox.If
thebatteryterminalsarecorroded,cleanthemwitha
solutionof4partswaterand1partbakingsoda.Apply
alightcoatingofgreasetothebatteryterminalsto
preventthemfromcorroding.
Batteryvoltageandamperage:12volts,190cold
crankingamps
27